LCUP

Contrex, Inc. Precision Motion Controls

HOME > PRODUCTS > Motion Controllers > M-Series Controls > M-Trim

Loyal Customer Upgrade Program

Enhance the performance and extend the life of your M-Series controllers

Upgrade from this		to like factory new!

OVERVIEW

Your loyalty pays. Contrex is excited to offer an upgrade to loyal customers with installed Contrex (or Fenner) M-Series controllers. This includes the M-TRIM, M-DRIVE, M-TRACK, M-ROTARY, M-CUT, M-SHUTTLE, and M-TRAVERSE precision motion controllers.

Take advantage of very favorable pricing while improving the performance of your controllers with new software and keypad, and extending the life of your controller with a new battery*, new gasket, and a new 1 year warranty. Call Contrex at (800) 342-4411 to find out more about this cost saving program.

*Units that are older than ten years old or say "Fenner" on the keypad are likely nearing their internal battery expiration. To prevent a potential unplanned machine shutdown and loss of control parameters, the internal battery must be replaced prior to expiration.

UPGRADE BENEFITS

Contrex will upgrade any Contrex (or Fenner) M-Series controller to that specific model’s current software version. The upgrade also includes:

Clean and refurbish your controller’s electronics to current model specifications
Replace the keypad and gasket
Replace any damaged bezel, chassis, and labels
Replace the internal battery
New 1 year warranty

PRICING

Model	List Price-New	Upgrade Price	Total Savings
M-TRIM	$970	$680	30%
M-TRIM w/ Analog	$1,155	$810	30%
M-DRIVE	$1,005	$700	30%
M-DRIVE w/ Analog	$1,185	$830	30%
M-TRACK	$1,730	$1,210	30%
M-ROTARY	$1,730	$1,210	30%
M-SHUTTLE	$1,730	$1,210	30%
M-TRAVERSE	$1,730	$1,210	30%
M-CUT	$1,375	$1,210	12%

RESTRICTIONS

This is not an offer to sell refurbished/remanufactured units. The units sent in for upgrade must contain a power supply, logic, and display board (and analog board if applicable); in any condition. Units sent in with back panel connectors will be sent back to the customer with connectors. Units sent in without back panel connectors will be sent back to the customer without connectors.